🔧 Speaking of dismantling pulleys, it's really a headache! Especially when it refuses to come down alive or dead, I really want to shout 'collapse' in my heart! But don't worry, today I'm going to share some practical tips to help everyone easily solve this little trouble. Promise me, come and take a look at these little tricks, I guarantee you'll find them super useful after using them!
one ️⃣  Use appropriate tools for disassembly
🔧  Tool selection: Choosing the right tool is almost half the battle when disassembling the pulley. Recommend using a plum blossom wrench to loosen the positioning bolts on the motor base, it's really super easy to use! A plum blossom wrench can provide better grip strength and avoid damage to the pulley or surrounding components during disassembly.
🔩  Operation details: A ring wrench is more suitable for this task than an open-end wrench because it can better grip bolts and is less likely to slip. Make sure to carefully check the size of the bolts and select the right wrench before disassembly in order to proceed more smoothly.
two ️⃣  Disassemble with the help of a rubber rod and hammer
🔨  Method introduction: If the pulley is too tight to drive people crazy, try this method: place a rubber rod on the screw and gently tap it with a hammer. This can utilize the elasticity of the rubber rod to avoid causing hard impact on the pulley, which is really super practical!
💡  Safety Reminder: Be careful when using a hammer and ensure that the impact force is moderate. The rubber rod not only transmits force, but also protects the screw and pulley from damage, making it a skilled disassembler.
three ️⃣  Adjust the position of nuts and washers
🔩  Position adjustment: During disassembly, adjusting the position of nuts and gaskets is a key step. First loosen the large nut, then remove the gasket at the back, which can help loosen the tightened pulley.
🔧  Attention to details: When adjusting, be sure to remember the relative positions of each component for accurate resetting during subsequent installation. Be careful during operation to avoid losing or misplacing these small parts, as they are crucial for the smooth disassembly of the pulley!